Can I use two different antennas on the same node if I leave Tx and Rx set to diversity?  I'm thinking a small omni to support a cluster of nodes and a dish to reach another cluster on the far side of a valley. Same setup over there. The distance is about 3 miles. 

Thanks

Brian, AG4BC

If it already has DD-WRT on it, you can go into its firmware update and flash it to HSMM-Mesh without too much trouble. (usually easier than flashing in Lynksys')

73

KTF

Hi all.Still getting the network set up here.Have the home qth,work,eoc going.I have used various versions.Mainly 1 and 2.I buy them on the e-place usually $20.00 or less...The problem with that is usually you can not tell the version.Sometimes they do tell you,hi..I just picked up a version 1.It was already flashed with dd-wrt.Is it compatable with mesh? I am wanting to take one in the rv,But do I give up wrt in leiu of mesh?  thanks all john w5jmw

I  think a multi directional antenna is also a good option for getting good signal. Because this multi directional antenna works to transmit signals from multiple directions.

tv aerial | london aerial installation

I have an option to buy one of these. Good for HSMM? This one is a bit different than the other T-Mobile router thats good.

-Sly

At this time the tunnels are purely experimental and not ready for general consumption.  OLSR is very unstable when the tunnel is active.  Long running nodes have had several thousand olsr restarts.  We have new olsr code to try and new ways of tunneling to test.  We will be sure to let everyone know when the situation improves.

73
ad5oo

Hello Mike, Christy here, Apple Valley.

I like dancing little guy, megaherz guy?

hay I am on my way, got the yagi pointing west.

waiting on more components to put this puppy up on a pole.

when I get powered up will post on map.

thanks for putting this together.

73

KB6LTY

I came across this article describing using virtual tunnels with HSMM-MESH being under development, however I haven't been able find any current information on the status.

Is there a way to do this with 0.4.3 or are we still in the thick of development?

Got my HSMM-MESH node up and running. Indoors right now, but I'll be moving it to the roof with high-gain antennas for better range down the road.

No advertised services right now, however I will be adding a Raspberry Pi running a D-RATS reflector and a TeamSpeak 3 server. I'll also be adding a webcam eventually as well.

I have one wrt54g that I've reporgrammed and an external ~12 db yagi from ebay.

the yagi looks like this one, but with 13 directors.

Radiolabs.com claims 1 mile with it.

i purchased mine from ebay for ~$10 delivered: http://goo.gl/76h2Y

I haven't connect to another node yet.  I shuda gotten 2 wrt54g at the fleamarket.

jim

Yes it will! I have two of the WRT54G-TM's. However, you must follow each step in the 4th post in the link below in order to get HSMM-MESH to work on this router.

http://www.broadband-hamnet.org/hsmm-mesh-forums/view-postlist/forum-2-hardware/topic-180-wrt54gtm.html

I see from time to time on the map a Mobile HSM-MESH op.

What is being used mobile, please, and at what maximum distance can a mobile hold a connection?