I'm trying to set up a mesh node. I have a Linksys WRT54G v 3.1 router. Following the online directions, I flashed it with the file 'bbhn-3.1.0-wrt54g-2.4-squashfs.bin'. Everything seemed to work as advertised. When the router came up as a mesh node, I did the initial configuration with a username of WA7SKG-100 and a password that contained a number and an "@" sign. It accepted that and rebooted as the instructions said it would. However, after the reboot and it identifying itself as WA7SKG-100, when I try to go into setup, a popup window asks for the username and password. When I enter it, the box just blanks and asks again for U/P. At first, I thought maybe I forgot what password I set (I did break for dinner). I finally reflashed with tftp and started over. This time I wrote down the password. Same problem. Reflashed again and reconfigured, this time using an alpha only password. Same problem. I cannot get in for any further configuration after setting a username and password.

Any ideas on what I am doing wrong? I need to get this going for Field Day.

I have a need to completely restore from HSMM meshnode.  I can connect, but of course, when I try to re-flash the .bin file I get an error.  I was able to SSH to the antenna, but I dont know what commands to run, or how to upload the bin file via SSH.  I can't seem to TFTP either.

Good day,

Anyone successful at getting the PI3 wireless adapter working with HSMM-PI?  If so, any special configuration?   My Pi3 will see the network and other HSMM devices but other devices do not see the Pi.

Thanks in advance.

Bob

K6MBY

Sequim, WA

Double and Triple Post, Sorry.

Double and Triple post. Sorry.

Hello everybody, I live in Greeneville, Tn and just flashed a wrt54g v4.

I have a TP Link 24dbi antenna and a biquad at the focal point of a 3' dish that is a strong performer.

If that isn't enough, I have a 10w 13cm shireen model 24601 amplifier.

I also have 4 Deep cycle batteries, 2 100 watt solar panels and a charge controller.

I live in the mountains and have access to a tall peak and would like to set up a node but I'm not sure if there is anyone close enough.

I did see that there is a node in Knoxville, and another in Johnson City. I am about halfway between the two. (about 5 miles north of exit 30 on i81 on 70)

Is it feasible that i could link between the two?

Thanks for any suggestions or info.

73

KN4AYP

If anyone is interested I've made a short how-to with the necessary files. Email me at aim.com and I'll send it to you. I have contacted the webmaster to see if the file can be hosted here where it's available to everyone.

I got a heck of a deal on some Polycom IP450 phones.. Followed the directions located in another thread for a different Polycom model and think I have gotten close..

Has anyone gotten these to work? I have them loading sip.ld from my asterisk server, but keep getting "Line not Provisioned" alerts on the phone.. 

Any help accepted and appreciated..

Gene N9MXQ